The new NG3 is a further development of the proven and versatile NG2.
With new technologies and functions, we have succeeded in developing the NG3 into the calibrator of the equally new UV-Mini. With the NG3, every operator is able to calibrate the UV-Mini. The user is guided through the individual calibration steps without having to scroll through a manual in parallel. You can find more information about the UV-Mini on this homepage under: Devices > UV-Mini Sensor.
Another function is the NG3 as a battery tester. The NG handheld devices require energy storage for their mobility and have an internal rechargeable battery. The capacity of a rechargeable battery can decrease after hundreds of charge cycles. With the NG3, the capacity of the rechargeable battery used is measured and shown on the display. This means that the user can always find out about the available time span in which the NG3 is supplied with enough energy and is functioning.
- internal automatic continuous validation review
- internal automated material rolling direction determination
- can be operated via smartphone with photo documentation
- Battery operated for more than nine hours
- Easy to use
- flexible use in a wide variety of environments
- Calibrator of the UV-Mini
- Battery tester
The measurable oil thickness is between 0.05 and 6 µm (approximately g/m2) oil layer thickness.
Calibrations are standard for:
- untreated cold sheet
- hot-dip galvanized sheet
- fire-aluminum sheet
- electrolytically galvanized sheet (automatic phosphating detection)
- galvannealed
- Aluminum (mill finish and EDT)
Aluminum surfaces as well as some steel surfaces are very inhomogeneously structured. They must always be measured with the handle at right angles to the rolling direction
You will have read this note many times. But what if the direction of rolling cannot be seen with the naked eye?
Then the compass function, which can be provided for Infralytic NG2 sensors, will help you.
Here you will find more information about the compass function.
Just take a few measurements in passing? Sure it’s possible!
And best of all: The measured data is immediately available for evaluation. Use our Infralytic Android App for this.
Here you can find more information about the smartphone app.
Over 80 calibrations are available from stock.
Upon request, users can develop and program specific calibrations on their own. New functionalities in connection with the associated software allow you to develop your own calibrations easily.
Measurement method:
Infrared spectroscopy
Measuring range:
0,05- 6 g/m²
Measurement accuracy:
0,02 – 0,3 g/m²: +/- 0,015 g / m²
0,3 – 2 g/m²: +/- 0,2 g/m²
> 2 g / m²: +/- 10% from the measured value
Repeatability:
< 0,0010 g/m² Measurement resolution:
up to 0,001 g/m²
Surfaces:
all that are not extremely shiny e.g.
Cold strip, hot-dip galvanized,
electrolytically galvanized, phosphated,
aluminized ZnMg surfaces, galvanized
Aluminum – uncoated, pre-treated
Lubricants:
Mineral oil, tixotropic mineral oils, hotmelt, waxes,
other organic lubricants after special calibration
Measuring distance:
8mm +5/-2mm
Ambient temperature:
+0°C to 45°
Protection class:
IP 65