New NGO3-W measuring head for contact free water film measurement in moving processes.
Companies are facing rising demands to improve their energy balance. The rolling of slabs requires a lot of energy. After the rolling process, the strip is wound up. Here, the emulsion required for rolling is blown off at great expense and the strip is dried using radiant heaters and fans.
Our water measuring head NGO3-Water measures the remaining amount of water on the belt in real time while the belt is being wound at production speed. With a distance tothe strip of 200 mm the measuring head can e.g. be mounted between the last scaffold and the reel.
The information about the measured amount of water and lubricant on the belt is shown in separate displays in mg / m² and directly on the monitor of your operator. This means that the drying of the belt can be adjusted according to the measured values and it does not have to be heated and blown excessively. The large danger of water ending up being wrapped in the coil is history.
non-contact measurement in real time
internal automatic continuous validation review
color, graphic display
Independent of the line speed
Band vibration compensation
200mm safety distance between measuring head and material
Independent of residual oil
Areas of application
Special sensor for measuring emulsions.
The sensor is used e.g. in
Heavy plate rolling mills
Continuous casting plants
Hot rolling mills
0.05 – 6 g / m²
0.10 – 0.5 g / m²: +/- 0.025 g / m²
0.5 – 2 g / m²: +/- 0.2 g / m²
> 2 g / m²: +/- 10% of the measured value
< 0.0010 g / m²
up to 0.01 g / m²
all that are not extremely shiny e.g.
Cold strip, hot-dip galvanized,
electrolytically galvanized, phosphated,
aluminized ZnMg surfaces, galvanized
Aluminum – uncoated, pre-treated
Remaining lubricants being tolerated:
Mineral oil, tixotropic mineral oils, hotmelt, waxes,
other organic lubricants after special calibration